Black & Decker Edger LST136 ユーザーズマニュアル

WARNiNG:

Burn hazard. Battery liquid may be flammable if

exposed to spark or flame.

• Charge the battery packs only in Black & Decker chargers.

• DO NOt splash or immerse in water or other liquids. This may

cause premature cell failure.

• Do not store or use the tool and battery pack in locations where

the temperature may reach or exceed 105°F (40˚C) (such as

outside sheds or metal buildings in summer).

WARNiNG:

Never attempt to open the battery pack for any

reason. If battery pack case is cracked or damaged, do not insert into

charger. Do not crush, drop or damage battery pack. Do not use a

battery pack or charger that has received a sharp blow, been

dropped, run over or damaged in any way (i.e., pierced with a nail,

hit with a hammer, stepped on). Damaged battery packs should be

returned to service center for recycling.

WARNiNG:

Fire hazard. Do not store or carry battery so that

metal objects can contact exposed battery terminals. For example, do

not place battery in aprons, pockets, tool boxes, product kit boxes, drawers,

etc., with loose nails, screws, keys, etc. transporting batteries can

possibly cause fires if the battery terminals inadvertently come in

contact with conductive materials such as keys, coins, hand tools and

the like. The US Department of Transportation Hazardous Material

Regulations (HMR) actually prohibit transporting batteries in commerce or on

airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are

properly protected from short circuits. So when transporting individual

batteries, make sure that the battery terminals are protected and well

insulated from materials that could contact them and cause a short circuit.

NOTE: Batteries should not be put in checked baggage.
StORAGE RECOMMENDAtiONS

1. The best storage place is one that is cool and dry away from

direct sunlight and excess heat or cold.

2. Long storage will not harm the battery pack or charger.

ChARGiNG PROCEDuRE

Black and Decker chargers are designed to charge Black and Decker

battery packs: LCS36 (2 hrs), LCS436 (6 hrs).

1. Plug the charger into an appropriate outlet before inserting the

battery pack.

2. Insert the battery pack into the charger.

3. The green LED will flash indicating that the battery is

being charged.

4. The completion of charge is indicated by the green LED

remaining on continuously. The pack is fully charged and

may be used at this time or left on the charger.

Recharge discharged batteries as soon as possible after

use or battery life may be greatly diminished.

ChARGER DiAGNOStiCS

This charger is designed to detect certain problems that can arise

with the battery packs or the power source. Problems are indicated

by one LED flashing in different patterns.

BAD BAttERY

The charger can detect a weak or damaged battery. The red

LED flashes in the pattern indicated on the label. If you see

this bad battery blink pattern, do not continue to charge the

battery. Return it to a service center or a collection site for

recycling.

hOt/COlD PACK DElAY

When the charger detects a battery that is excessively hot

or excessively cold, it automatically starts a Hot/Cold Pack

Delay, suspending charging until the battery has normalized.

After this happens, the charger automatically switches to the

Pack Charging mode. This feature ensures maximum battery

life. The red LED flashes in the pattern indicated on the label

when the hot / cold pack delay is detected.

lEAViNG thE BAttERY iN thE ChARGER

The charger and battery pack can be left connected with the green

LED glowing indefinitely. The charger will keep the battery pack

fresh and fully charged.