Behringer Xenyx XL2400 オーナーマニュアル
17
XENYX XL3200/XL2400/XL1600 User Manual
6. Modifications
◊
These modifications require soldering. Attempt only if you are
experienced in using an iron on PCBs. Otherwise, refer to qualified
personnel. After modification the warranty becomes void.
experienced in using an iron on PCBs. Otherwise, refer to qualified
personnel. After modification the warranty becomes void.
◊
We wish to be absolutely clear that BEHRINGER cannot be held
responsible after you start disassembling your XENYX. If you make
much of your warranty privileges, think again.
responsible after you start disassembling your XENYX. If you make
much of your warranty privileges, think again.
◊
Links should not be threaded into the holes on the PCB, but are to
be soldered to the tinned areas around the holes. Bend the links a
little upwards.
be soldered to the tinned areas around the holes. Bend the links a
little upwards.
6.1 Mon/Aux sends > post-EQ
Pre-fader switched monitor sends and aux sends are tapped off before the
equalizer. Do you prefer post-EQ? What are you waiting for? You don't have to
look far—the necessary information is found on the bottom side of the unit.
◊
Make sure to turn off the mixer and disconnect it from the mains before
removing the cover.
removing the cover.
1) Strip the PRE EQ lead.
2) Solder a POST EQ link into place.
3) Make these modifications to as many channels as required (does it have to be
3) Make these modifications to as many channels as required (does it have to be
all of them?).
6.2 Direct Out > pre-fader
If you prefer to use the Direct Out pre-fader than post-fader, the signal needs
to be tapped off before the fader and not after the fader. To perform this
modification, find the label “DIR-OUT” on the circuit board.
◊
Make sure to turn off the mixer and disconnect it from the mains before
removing the cover.
removing the cover.
1) Strip the POST FADER lead.
2) Solder a PRE FADER link into place.
3) Make these modifications to as many channels as required.
3) Make these modifications to as many channels as required.