Bunn Juicer JDF-4S ユーザーズマニュアル

14

FIG  17  Adjusting Water Flow

Using 1/4" allen wrench

 

2+1 

*3.75 fl. oz (111 ml) 

Prune Juice 

16.0%

 

 

per 3-second test 

Other 

*

 

 

 

Orange Juice 

11.8% 

 

4+1 

 

Pineapple Juice 

12.8%

 

 

 

Cranberry Fruit Cocktail 

14.0% 

 

 

*4.0 fl. oz (118 ml) 

Grapefruit Juice 

10.6%

 

  

per 3-second test 

Lemonade 

 

 

 

5+1 

 

Apple Juice 

12.0% 

 

 

 

Fruit Punch 

 

 

 

 

Grape Juice 

13.0% 

 

3+1 through 7+1 

 

Other 

* 

 

Above 7+1 

*4.0 fl. oz (118 ml) 

Other 

*

 

 

per 3-second test

 

High Viscosity Juice 

2.25 - 3.0 fl. oz (66.5 - 89 ml) 

As Required 

-

 

 

 per 3-second test

*Maximum flow rate may be less depending on the water pressure supply at each location.

 Note: Information for specific products listed in this table is to be used for reference only. Consult the product 

label for exact mix ratio and/or brix %. See product label for target brix %.

1.  Place a graduated measuring cup or the large chamber of the empty 

brixing cup (BUNN-O-MATIC part number 33095.0000) under the ap-

propriate dispense nozzle. Place the Program switch in the ON position.

2.  Press and release the desired “Product Dispense Switch” three times.

(On Portion Control models, use the plus/stop switches)

3.  The selected position will dispense water (no concentrate) only for 3 

seconds.

4.  Measure the water dispensed.

5.  Adjust the water flow rate Fig 17, (clockwise to increase flow rate; 

counterclockwise to decrease flow rate) to the corresponding product 

mix ratio as follows:

P3586

6.  Repeat steps 1 through 5 as necessary until the correct water flow rate is achieved.

7.  Repeat steps 1 through 5 for the remaining dispense positions.

8.  Place the Program switch back into the OFF position.

1.  Disconnect the dispenser from the power source.

2.  Remove the drip tray.

3.  Remove the two screws securing the splash panel and remove the splash panel

4.  Locate the adjustment knobs on the circuit board.

5.  Turn the adjustment knobs clockwise to increase speed and counterclockwise to decrease speed.

6.  The knob positions directly correspond to dispense station locations.

NOTE: Some 2S models have 4 adjustment knobs on the circuit board. For these models use the two left most 

knobs to make pump speed adjustments. Left most being station #1 (left side dispense) and left center being 

station #2 (right side dispense).

7.  Reinstall the splash panel and drip tray and reconnect the dispenser to the power source.

44744 032811