Bunn bunn jdf-2 ユーザーズマニュアル

14

7.  Repeat steps 3 through 6 as necessary until the correct water flow rate is achieved.

8.  Repeat steps 3 through 7 for the remaining dispense positions.

9.  Exit the “Pump Speed Programming” mode by simultaneously pressing both “Hidden Switches”. Note that 

the beeper sounds twice and the “PROGRAM” indicator extinguishes.

38310 010406

1.  Enter the “Pump Speed Programming” mode by simultaneously press-

ing both “Hidden Switches” Fig 5 or Fig 6. Note that the beeper sounds 

twice and that the “PROGRAM” indicator begins flashing.

2.  Place a graduated measuring cup or the large chamber of the empty 

brixing cup (BUNN-O-MATIC part number 33095.0000) under the ap-

propriate dispense nozzle.

3.  Press and hold the desired “Product Dispense Switch” Fig 5 (“+/Stop 

Switch” Fig 6, for portion control dispensers) for 5 seconds. Note that the 

beeper sounds once per second (6 times, total) during this period.

4.  At the end of the 5 second period, the selected position will dispense 

water (no concentrate) for only 3 seconds.

5.  Measure the water dispensed.

6.  Adjust the water flow rate Fig 8, (clockwise to increase flow rate; counterclockwise to decrease flow rate) to 

the corresponding product mix ratio as follows:

 

2+1 

*3.75 fluid ounces (111 ml) 

Prune Juice 

16.0%

 

 

per 3-second test 

Other 

*

 

 

 

Orange Juice 

11.8% 

 

4+1 

 

Pineapple Juice 

12.8%

 

 

 

Cranberry Fruit Cocktail 

14.0% 

 

 

*4.0 fluid ounces (118 ml) 

Grapefruit Juice 

10.6%

 

  

per 3-second test 

Lemonade 

 

 

 

5+1 

 

Apple Juice 

12.0% 

 

 

 

Fruit Punch 

 

 

 

 

Grape Juice 

13.0% 

 

3+1 through 7+1 

 

Other 

* 

 

Above 7+1 

*4.0 fluid ounces (118 ml) 

Other 

*

 

 

per 3-second test

 

High Viscosity Juice 

2.25-3.0 fl.oz. (66.5-89ml) 

As Required 

-

 

 

per 3-second test

*Maximum flow rate may be less depending on the water pressure supply at each location. 

Note: Information for specific products listed in this table is to be used for reference only. Consult the 

product label for exact mix ratio and/or brix %. See product label for target brix %.

FIG  7  Adjusting Water Flow

Using 1/4” allen wrench