Bowflex 3000 ユーザーズマニュアル

Assembly Manual

É

 



*"7 ,





Note:   During calibration, observe the walking belt alignment.  

Belts do not need to be perfectly centered, but if they 

are far enough from center to cause a scraping sound, 

follow the belt alignment instructions in the Owner’s 
Manual. 

   Failure to calibrate your machine prior to use could result in  
  machine failure and could cause injury.
   During the entire calibration process, stand on the side 

Note:    Re-calibration is also neccessary in the event of a 

power outage or if a component like a belt or motor 
has been replaced.

18-1  Plug the power cord into the the wall outlet.
18-2  Turn on the Main Power Switch (See Figure 18-1).
18-3   Stand on the side foot support platforms or rubber floor 

mat. Do NOT stand on the belts.

18-4   Hold down the POWER and SLOWER buttons. Insert the 

Safety Key.

Note:    If the Safety Key is not fully inserted into the safety 

keyhole, the TreadClimber

®

 will not operate.

18-5   Release the POWER and SLOWER buttons. The TIME 

display will read “CAL”, PrSS”,”Strt”.

18-6  Press the START/STOP button to start calibration.
Note:    The belts will start and stop and the displays will show 

various numbers that relate to the calibration process. 
Do NOT interrupt calibration.

18-7   Calibration will take about 3 minutes. When calibration 

has finished “CAL” “PASS” will show in the TIME 
display.

18-8  Remove and re-insert the Safety Key to clear the display.
When the Bowflex

®

 TreadClimber

®

 exercise machine has 

completed calibration, you may begin your workout.
Note:   During calibration the 30 meter LED on the TC5000 

signifies the belt speed sensor, 305 meters LED is the 
step sensor. Some models of the TC 3000 will show the 
step sensor in the DISTANCE window as a heart and the 
speed sensor in the SPEED window as a heart.