Bosch 4100 ユーザーズマニュアル

8. With one hand, hold the front of the barrier guard assembly 

by the metal “fork”.  With the other hand, hold the guard
release lever 

5 up (Fig. 7).

9. Lower the rear of guard assembly and slip the cross bar 

6 into

the rear notch 

7 on top of the riving knife 2 (Fig. 7).

10. Lower the front of the guard assembly 

4 until the metal “fork”

is parallel with the table (Fig. 8).

11. Press down on the guard release lever 

5 until you feel and

hear it snap into the locking position. Check that the guard
assembly is securely connected (Fig. 8).

12. Attach the Anti-Kickback Device 

7 into the flat recessed 

area 

8 of the riving knife 2 (Fig. 9). 

13. Squeeze the compression pads 

9 while nesting the device

into the flat area (Fig. 9).

14. Release the compression pads such that the Anti-Kickback

Device locks onto the riving knife immediately behind the
guard assembly. Check that the attachment pin is securely
connected into locking hole.  Carefully raise and lower the
pawls 

10 – when letting go, the spring-loaded pawls must

come down and contact the table insert (Fig. 9). 

Hint: Position the Anti-Kickback Device behind the flat recessed
area and slide it towards the front until it drops into the recessed
area – then release the compression pins.

Note: The two attachments are independant of each other, so
the Anti-Kickback Device can be attached before the Guard
Assembly.