Bixolon CM014-2 プリント

Package Contents:
(1) CM014-2 - Mini windshield suction or dash mount
(1) APTTGO520 - Adapter plate for TomTom GO™ Series
(1) AP036 - Adhesive circular disc
(1) Alcohol cleaning pad

Do not place mount in or near an air bag deployment zone 
or where it will obstruct view of the road.

CM014-2 
Mini Windshield 
or Dash Mount

AP036
Adhesive Disc

Patent Pending

Patented

Safety Precautions
Do not install Arkon products over an air bag cover or within the air 
bag deployment zone.  Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or      
air bag deployment. 

Arkon is not responsible for any damages caused to your car, your 
device, or yourself due to the installation or use of this pedestal mount.

Consumer Hotline:
USA     (800) 841-0884
INT’L    (626) 254-9005
Monday - Friday 9 am - 5 pm, PST

Arcadia, CA 91006 USA

Designed in USA | Made in Taiwan

© Copyright 2009 Arkon Resources, Inc.

TomTom Device Compatibility:
• TomTom GO 520 / 530 / 720 / 730 / 920 / 920T / 930

APTTGO520
Adapter plate for 
TomTom GO x20, x30

Check Compatibility

Step 1.

Step 2. 

Find a safe location on the dash or console.  Use the inclu-
ded alcohol pad to clean the mounting surface if necessary.  
Remove the paper backing on the adhesive disc and fi rmly 
press in place. 

Place the pedestal’s suction base (A) over the center of the 
circular disc.  While fi rmly holding the pedestal on top of 
the disc, fl ip the base lever down (B) to the locked position.  

Step 1.

Attach the adapter plate by sliding it up into the slot on the 
back of the TomTom GO 520, 530, 720, 730, 920, 920T or 930 
device as shown.  Attach the device as shown below.

Step 1.

Step 2. 

Find a safe location on the interior of the vehicle’s wind-
shield to mount the pedestal.  Firmly push the suction base 
(A) against the windshield and fl ip the base lever down (B) 
to the locked position.  See diagram below. 

Adjust the angle of the pedestal arm by tightening the 
angle adjustment knob (C) at the base to the desired angle. 

TomTom brand name and GO product name are trademarks, or registered trade-
marks of TomTom International NV.  Arkon Resources, Inc. is not affi

  liated with 

TomTom International NV.

Step 1.

Attach the device and adapter plate to the mount by 
inserting the dual T-tabs of the mount (D) into the T-slots 
of the adapter plate (E).  Adjust the angle of the head by 
tightening the head adjustment knob (F).