Balay 3TI60081A インストール手順

25

Do not allow the water inlet hose to be:
– Kinked or squashed, modified and cut (strength no longer guaranteed).

Note the water pressure in the mains supply:
– The water pressure should be between 50-900 kPa (0.5-9 bar) (at least 

Connect the inlet hose to the ¾" cold water tap.

Tighten the screw connections only by hand. Do not remove the filter from 
the inlet hose.

– Open the water tap carefully, checking the leak tightness of the connec-

tion points.

– N.B.: The screw connection is under mains water pressure.

– Do not kink the outlet hose or pull it lengthways.

– Height difference between the installation surface and the drain:

max. 90 cm, min. 50 cm.

Secure the connection point with the 24-40 mm hose clamp.

The washing machine must only be connected to an alternating current 
via a properly installed earthed socket.

Only use earth-leakage circuit breakers with the following symbol: 

The mains voltage must correspond to the voltage specifications on the 
washing machine (rating plate).
The connected load and fuse required are specified on the rating plate.

Make sure that:

– the mains plug fits the socket.
– the cable cross-section is adequate.
– the earthing system is properly installed.
– the appliance is not standing on the mains cable,
– the mains plug is accessible at all times.

Changes to the mains cable may only be carried out by a qualified 
electrician. 

Do not use multiple plugs/adapters or extension cables.

Mains plug:
– Do not insert the plug into the socket or pull it out if your hands are wet.
– When removing the plug from the socket, pull on the plug body only, 

not the cable.

– Never pull the plug out during operation.