West Elm Square Base Floor Lamp 組み立て手順

page 1 of 1

assembly instructions

7345762/7345804/7345739 - 7/05

: square base floor lamp

1. Pull the wire from the upper tube (E) through the lower tube (C). Turn the
lower tube (C) onto the upper tube (E) in a clockwise direction to tighten.

2. Pull the wire from the lower tube (C) through the base (D). Insert lower tube
(C) into base (D). Turn the lamp base (D) in a clockwise direction to tighten.

4. Place shade on harp and secure by tightening cap nut (F) onto threaded rod.

3. Press the sides of the harp (A) together in order to slide into slots in saddle (B).

5. Screw in lightbulb.

Use with a type A bulb. DO NOT USE WITH A BULB EXCEEDING 100 WATTS.

Electric bulb should be centered inside the shade, making sure it does not touch the sides of the shade.

Recommended for use with west elm lamp shades only.

CARE INSTRUCTIONS.

Hardware may loosen over time. Periodically check that all connections are tight.

Wipe base with a soft, dry cloth. To protect the finish, avoid the use of all chemicals and household cleaners.