West Elm Medallion Tapered Pendant 組み立て手順

Medallion Tapered Pendant

(1) Mounting plate (E)  

(1) Canopy (F) 

·Stud mounting is recommended. Use proper hardware for your wall type. When in doubt consult your local 

hardware store. For your safety, it is strongly recommended that two people hang the lamp.

·Electric bulb should be centered inside the pendant shade, making sure it does not touch the outer sides.

·These instructions are provided for your safety. It is important that they are read carefully and completely before 

assembling fixture.

·This fixture has been rated for up to (1) 40-watt maximum TYPE A standard bulb (not included). To avoid the 

risk of fire, do not exceed the recommended wattage.

assembly instructions

page 1 of 2

·To reduce the risk of fire, electrical shock or personal injury, always turn off

and unplug lamp and allow it to cool prior to replacing light bulb.

·Do not touch bulb when fixture is turned on. Do not look directly at lit bulb.

·Keep flammable materials away from lit bulb.

·Remove all parts and hardware from box along with any plastic protective packaging.

·Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware. 

·For your safety and convenience, assembly by two people is recommended

• Electrical tape 

• Screwdriver

07/08 - 7087661

A

E

B

C

F

G

H

I

D

• 
• 

• 
• 
• 

• 

(2) Mounting screws (C) 

• 

• 

(1) Green ground screw (B) 

• 

(2) Plastic wire caps (A)

(2) Canopy screws  ( D )

  

C

grounding screw 1x

B

A

canopy screws 4x

mounting screws

2x

D

wire caps

3x

(1) Lamp Socket (G) 
(1) Socket Ring (J) 
(1) Ceramic Shade(H) 

1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE 

BOX/CIRCUIT BREAKER.

2. Carefully unpack all fixture parts and hardware and lay out on a clear workspace.

3. Place the ceramic shade (H) onto the lamp socket (G). 

4. Screw the socket ring (I) onto the lamp socket (G).

5. Carefully inspect the chandelier's fixture wires. The neutral fixture wire is white or 

marked “N”.  The hot fixture wire is black or mar ked “L”. The yellow-green or bare 

wire is the ground wire.

6. Attach the ground wire from the fixture to the ground junction box wire from the 

outlet (usually green or bare wire). Fasten each together with a plastic wire 

connector (A) and wrap the connection with electrical tape. Be sure that no wire 

strands are exposed. If your outlet box does not have a ground wire, be sure to insert 

the green ground screw (B) into the mounting plate (E) facing down, and wrap the 

fixture's bare ground wire around the ground screw. IT IS IMPERATIVE THAT THE 

OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.