Wright Manufacturing 14SH654 ユーザーズマニュアル

ページ / 28
 
11 
 
Use caution if it is your first time.  Now try moving the 
hand control levers, one at a time, very slightly, 
forward and backward.  Gradually increase your 
speed until you are well acquainted with the 
operation of the hand controls and the mower’s 
behavior.  After gaining a good feel for how the 
mower handles, gradually attempt higher engine 
speeds until familiar with operation at full throttle 
engine speed. 
 
How to Stop and Park the Mower 
Come to a complete stop.  If the blades are on, 
turn them off using the switch on the instrument 
panel.  Make sure the control levers are in the 
exact neutral position.
  Set the parking brake, 
reduce the engine speed to idle, (keep engine 
running at the idle speed for about 1 minute)
 
shut off the ignition switch to stop the engine and 
then remove the key from the ignition switch.  Turn 
fuel valve to the “OFF” position.  The mower is now 
parked.  Do not leave mower unattended on a 
sloped surface. 
 
Driving the Mower Over a Curb 
To climb a curb, first see the 
Safety Instructions
 
section of this manual, especially the parts on: 
 
• 
Initial Operating Safety Guidelines
 
 
• 
Operation In Reverse
 
 
• 
Operation In Forward Direction
 
 
Next, raise the mower deck into the locked transport 
position.  This is the highest position for the mower 
deck.  Then drive the mower in reverse at a 45 degree 
angle to the curb (with the left side of the mower 
closest to the curb) until you are within an inch or two 
of the left-rear tire hitting the curb.  Stop and then 
gradually bump into the curb with that tire until it is just 
on top of the curb.  If the tire slips even while lurching 
the mower into the curb, then the curb is too high and 
you should use ramps or find another way.  The mower 
should still be at a 45 degree angle to the curb.  Now, 
while maintaining the same angle to the curb, continue 
to back up until the right-rear tire is close to the curb.  
Using the same technique lurch the right tire onto the 
curb.  After both wheels are on top of the curb, turn the 
mower counterclockwise and back up so the left caster 
wheel comes over and last should be the right caster 
wheel as the mower is twisting to the left 
(counterclockwise).  The technique works the best if 
you try not to drive backwards at a near 90 degree 
angle to the curb but get all of the wheels to go over 
while the mower is moving at least a 45 degree angle 
to the curb.  To drive off a curb, first try driving up onto 
it to make sure the curb is not too high.  If the curb is 
not too high, drive the right-front caster off first while 
driving toward the curb at a 45 degree angle (the curb 
should be to your right).  Then, maintain that 45 degree 
angle so the left caster goes over, then the right-rear 
wheel, then the left rear wheel.  WARNING: Do NOT 
step off the mower during ANY maneuver.
 
 
 
 
 
Never drive straight onto or off a curb.
 
Never drive straight onto or off a curb.  If you do the 
whole procedure at a very sharp angle it will tend to 
minimize the contact of the mower deck with the curb 
and you will be able to more safely control the mower. 
 
Mowing on Varying Terrain 
See the 
Safety Instructions
 section of this manual, 
especially the parts on: 
 
• 
Initial Operating Safety Guidelines
 
 
• 
Operation On Slopes
 
 
• 
Operation In Reverse
 
 
• 
Operation In Forward Direction
 
 
• 
Operation During Zero-Radius Turns
 
 
Fuel System/Fuel Shut-Off Valves 
 Do not fill fuel tank completely.  Fill until level is 1 inch 
below the bottom of the fill neck.  This will allow for 
the gas to expand. (Refer to fuel safety section of this 
manual) (use a minimum of 87 octane gasoline) (You 
may use gasoline containing up to 10% ethanol and 
gasoline containing up to 5% of methanol.) 
 
Close fuel shut-off valve for transport, 
maintenance and storage.
 
1. fuel cap 
2. roll-over vent 
3. fuel tank                            
4. fuel shut-off valve 
5. fuel gauge  
 
  
 
 
 
 
 
 
 
 
 
 
 
How to Adjust Neutral
 
Neutral refers to the mower movement when the 
engine is set to full throttle, parking brake is off, and 
the control levers are in the neutral position.  The 
mower should not move forward or backward during 
    
WARNING