Woodstock SHOP FOX W1829 ユーザーズマニュアル
-31-
Model W1829 (Mfg. Since 9/11)
SE
RV
IC
E
6. Move the straightedge to position A, as shown in
Figure 39. Turn the jack screw nearest the fence
counterclockwise until the end of the knife touches
the straightedge.
7. Move the straightedge to position B, as shown in
Figure 39. Turn the jack screw nearest the guard
counterclockwise until the end of the knife touches
the straightedge.
8. Slightly tighten the clamp screws, according to the
proper tightening sequence, as shown in
Figure 40.
Repeat
Steps 6–7 for the other cutterhead knife.
Note: Slightly tightening the clamp screws maintains
the knife position while performing the same step
on the other knife. They will be final tightened in a
later step.
8. Without disturbing the knife clamp, rotate the
cutterhead slightly to check the knife height.
— If the knife moves the straightedge slightly (
1
/
8
")
forward and back on the table, the knife height is
set correctly.
— If the knife does not move the straightedge slightly
(
1
/
8
") forward and back on the table, continue to
make fine adjustments with the jack screws until
the knife is set correctly.
10. When the knife heights are set correctly, final tighten
each of the knives' clamp screws according to the
proper tightening sequence (see
Figure 40).
11. Return the cutterhead guard to the operating
position and ensure it is working properly.
12. Re-align the fence and tables as needed.
13. Perform a test cut on suitable piece of scrap
material.
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 39. Straightedge positions A and B.
B
A
Figure 40. Knife clamp screw tightening
sequence.
1
2
4
3
Cutterhead knives are sharp and
laceration injuries may occur. Use
caution when handling the cutterhead
knives.