Whirlpool MEDB850YG インストール手順

Check code requirements. Some codes limit, or do not permit, 

installing dryer in garages, closets, mobile homes, or sleeping 

quarters. Contact your local building inspector.

 

■

A location allowing for proper exhaust installation. See  

“Venting Requirements.”

 

■

A separate 30 amp circuit.

 

■

If using power supply cord, a grounded electrical outlet  

located within 2 ft. (610 mm) of either side of dryer. See 

“Electrical Requirements.”

 

■

Floor must support dryer weight of 200 lbs. (90.7 kg). Also 

consider weight of companion appliance.

 

■

Level floor with maximum slope of 1" (25 mm) under entire 

dryer. If slope is greater than 1" (25 mm), clothes may not 

tumble properly and automatic sensor cycles may not  

operate correctly. 

 

■

For a garage installation, place dryer at least 18" (457 mm) 

above floor. 

 

■

Steam models only: Cold water faucets located within 4 ft. 

(1.2 m) of the water fill valves, and water pressure of 20-100 

psi (137.9-689.6 kPa). You may use the water supply for your 

washer using the “Y” connector and short hose (if needed) 

which are provided.

For each arrangement, consider allowing more space for ease  

of installation and servicing; spacing for companion appliances  

and clearances for walls, doors, and floor moldings. Space  

must be large enough to allow door to fully open. Add spacing  

on all sides of dryer to reduce noise transfer. If a closet door  

or louvered door is installed, top and bottom air openings  

in door are required.

IMPORTANT: Do not operate, install, or store dryer where  

it will be exposed to water, weather, or at temperatures below  

45° F (7° C). Lower temperatures may cause dryer not to  

shut off at end of automatic sensor cycles, resulting in longer  

drying times.

Location must be large enough to allow dryer door to open fully.

NOTE: Most installations require a minimum of 5" (127 mm) 

clearance behind dryer for exhaust vent with elbow. See “Venting 

Requirements.”