Whirlpool MEDB850YG インストール手順

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to Power Supply Cord Connection.

3-wire direct connection:

Go to Direct Wire Connection.

4-wire direct connection:

Go to Direct Wire Connection.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to Power Supply Cord Connection.

 If local codes do not permit connection of a 

cabinet-ground conductor to neutral wire, go to “Optional 

3-wire connection.” This connection may be used with 

either a power supply cord or a direct wire connection.

Before you start, disconnect power. Remove hold-down  

screw (D) and terminal block cover (A).

A. Terminal block cover 

B. External ground conductor screw

C. Center terminal block screw

D. Hold-down screw 

E. Neutral ground wire

F.  Hole below terminal block cover

E

C

B

F

D

A

Put power supply cord through the strain relief. Be sure that 

the wire insulation on the power supply cord is inside the 

strain relief. The strain relief should have a tight fit with the 

dryer cabinet and be in a horizontal position. Do not further 

tighten strain relief screws at this point.

Remove the screws from a 3/4" (19 mm) UL listed strain relief 

(UL marking on strain relief). Put the tabs of the two clamp 

sections (C) into the hole below the terminal block opening 

(B) so that one tab is pointing up (A) and the other is pointing 

down (D), and hold in place. Tighten strain relief screws just 

enough to hold the two clamp sections (C) together.

A

B

C

D