Whirlpool 1000 ユーザーズマニュアル

†

     A small amount of water runs through the pump to        

remove soil particles.

††

    Series 940 and 960 only.

Anytime during a cycle, press

CANCEL/DRAIN glows. The dishwasher pauses for about 5 
seconds and starts a 2 minute drain (if needed). Let the 
dishwasher drain completely. The light goes off when the 
dishwasher finishes the drain.

You can press Cancel/Drain again to stop the drain immediately. 
Remember to drain the dishwasher before starting a new cycle.

 A small amount of water remains in the dishwasher. This 

is normal.

Press Cancel/Drain before starting the dishwasher to clear all 
options and cycles.

Press a new cycle and/or options.

Press

CANCEL/DRAIN glows. The dishwasher pauses for 5 
seconds and starts a 2 minute drain (if needed). Let the 
dishwasher drain completely.

Check the detergent dispensers. If the main wash cup has 
opened and the detergent washed away, refill the cups as 
needed.

Close the door.

Press a new cycle and/or options. 

You can add an item anytime before the main wash starts. Open 
the door and check the detergent dispenser. If the main wash 
section is still closed, you can add items.

Lift up the door latch to stop the cycle. Wait for the spraying 
action to stop before opening the door.

Open the door. If the main wash detergent dispenser is still 
closed, add the item.

Close the door, but do not latch it. Wait 30 seconds for the air 
in the dishwasher to warm up. This reduces the amount of 
moisture escaping from the vent when restarting a cycle.

Close the door firmly until it latches. The dishwasher resumes 
the cycle after about a 5 second pause.

You can customize your cycles by pressing an option. If you 
change your mind, press the option again to turn the option off. 
Select a different option if desired. 

You can change an option anytime before the selected option 
begins. For example, you can press an unheated drying option 
any time before drying begins.

After a wash cycle, the dishwasher remembers the options used 
and uses the same options in the next wash cycle, unless you 
select new options or press Cancel/Drain.

Select this high-temperature option for improved cleaning of 
heavily soiled dishes. Selecting this option adds heat, water and 
time to the wash cycle. Heating the water helps improve washing 
results.

The Pots-N-Pans cycle, with the POWERSCOUR feature, is 
recommended for baked-on soil.

The POWERSCOUR feature is an option with Pots-N-

Pans, Heavy and Normal.

Select this option to heat the water to 140°F (60°C) in the main 
wash. This option adds heat and wash time. Heating the water 
helps improve washing results.

The Pots-N-Pans and Heavy cycles automatically use this 

option. High Temp Wash is an option with Normal, Low Energy, 
Low Energy/China and Crystal/China.

Select this option to dry dishes without heat and save energy. 
The dishes take longer to dry and some spotting can occur.

    

●

Use this cycle for rinsing 
dishes, glasses, and 
silverware that will not be 
washed right away.