United States Stove BEC95 ユーザーズマニュアル
EC95 11
FIGURE 9 - HEATER OPERATION INFORMATION
HEATER OPERATION
IMPORTANT: DO NOT USE THE HEATER UNTIL A PROFESSIONAL INSPECTION HAS BEEN MADE OF THE EN-
TIRE INSTALLATION BY YOUR LOCAL FIRE DEPARTMENT, FIRE MARSHAL OR BUILDING CODE INSPECTOR.
INSTALL A SMOKE DETECTOR ON EACH FLOOR OF YOUR HOME; IN CASE OF ACCIDENTAL FIRE FROM ANY
CAUSE IT CAN PROVIDE TIME FOR ESCAPE.
TIRE INSTALLATION BY YOUR LOCAL FIRE DEPARTMENT, FIRE MARSHAL OR BUILDING CODE INSPECTOR.
INSTALL A SMOKE DETECTOR ON EACH FLOOR OF YOUR HOME; IN CASE OF ACCIDENTAL FIRE FROM ANY
CAUSE IT CAN PROVIDE TIME FOR ESCAPE.
This heater must be operated as outlined in this manual or a serious fi re may occur.
THE PAINT ON THE EXTERIOR OF THE FIREBOX WILL GO THROUGH A CURING PROCESS DURING THE FIRST
FIRING OF THE HEATER AND WILL EMIT SMOKE AND ODOR. BE PREPARED FOR THIS BY RAISING A WINDOW
OR OPENING A DOOR TO PROVIDE VENTILATION.
The fi rst three times the heater is fi red, the fi re should be regulated so as to increase in intensity gradually to allow the
painted components to cure slowly and to allow the other components to adjust to their expanded size.
Be sure the room is adequately ventilated and the fl ue unobstructed before beginning a fi re in the heater.
TO BUILD A FIRE
THE PAINT ON THE EXTERIOR OF THE FIREBOX WILL GO THROUGH A CURING PROCESS DURING THE FIRST
FIRING OF THE HEATER AND WILL EMIT SMOKE AND ODOR. BE PREPARED FOR THIS BY RAISING A WINDOW
OR OPENING A DOOR TO PROVIDE VENTILATION.
The fi rst three times the heater is fi red, the fi re should be regulated so as to increase in intensity gradually to allow the
painted components to cure slowly and to allow the other components to adjust to their expanded size.
Be sure the room is adequately ventilated and the fl ue unobstructed before beginning a fi re in the heater.
TO BUILD A FIRE
Set the heater’s thermostat control knob to the “Hi” position. See fi gure 9.
Open the feed door (see fi gure 10) and lay paper and kindling on the grate in suffi cient quantities to ensure good
ignition.
Open the feed door (see fi gure 10) and lay paper and kindling on the grate in suffi cient quantities to ensure good
ignition.
WARNING: NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER
FLUID, OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS
WELL AWAY FROM THE HEATER WHILE IT IS IN USE. FAILURE TO COMPLY WITH THIS WARNING COULD
CAUSE AN EXPLOSION.
NO NOT USE GRATES AND/OR IRONS OR OTHER METHODS OF SUPPORTING THE FUEL.
FLUID, OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS
WELL AWAY FROM THE HEATER WHILE IT IS IN USE. FAILURE TO COMPLY WITH THIS WARNING COULD
CAUSE AN EXPLOSION.
NO NOT USE GRATES AND/OR IRONS OR OTHER METHODS OF SUPPORTING THE FUEL.
Light the fi re.
Close the feed door (see fi gure 10).
Add larger pieces of wood as the fi re gains in intensity. As soon as the fi re is established, wood may be added as
desired.
Close the feed door (see fi gure 10).
Add larger pieces of wood as the fi re gains in intensity. As soon as the fi re is established, wood may be added as
desired.
MAKE SURE THAT THE FEED DOOR AND CABINET DOOR ARE SECURELY CLOSED. CAUTION: OPERAT-
ING THE HEATER WITH THE ASH DOOR OPEN CREATES AN ABNORMAL FIRING CONDITION WHICH CAN
OVER HEAT THE HEATER, CHIMNEY AND ADJACENT COMBUSTIBLE MATERIALS. THIS CAN DRASTICALLY
SHORTEN THE HEATER’S LIFE AND VOID THE FACTORY WARRANTY.
ING THE HEATER WITH THE ASH DOOR OPEN CREATES AN ABNORMAL FIRING CONDITION WHICH CAN
OVER HEAT THE HEATER, CHIMNEY AND ADJACENT COMBUSTIBLE MATERIALS. THIS CAN DRASTICALLY
SHORTEN THE HEATER’S LIFE AND VOID THE FACTORY WARRANTY.
Set the heater’s thermostat control knob to a point midway between “Hi” and “Lo”. If the house or heating situation
requires a higher or lower setting to obtain the desired amount of heat, adjust the thermostat control knob appropriately.
requires a higher or lower setting to obtain the desired amount of heat, adjust the thermostat control knob appropriately.
1.
2.
2.
3.
4.
5.
4.
5.
6.