Siemens Camera Accessories 6AU1900-1AB32-0BA0 ユーザーズマニュアル
Configuring
3.3 Editing a Cam with CamTool
CamTool
3-14
Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0
2. Click a diagram to show the Cam menu.
6HJPHQWERXQGDU\
6HJPHQWERXQGDU\
)L[HGSRLQW
,QWHUSRODWLRQFXUYH WUDQVLWLRQ
6GLDJUDP GLVWDQFHGLDJUDP
9GLDJUDP YHORFLW\GLDJUDP
$GLDJUDP DFFHOHUDWLRQGLDJUDP
Figure 3-9
Cam segment replaced by SIMOTION CamTool with fixed point and transition
(interpolation polynomial)
3. Click the menu Cam > Upload cam. The cam is uploaded from the SIMOTION device.
4. After the upload, you can change back to OFFLINE status. Click the menu
4. After the upload, you can change back to OFFLINE status. Click the menu
Project > Disconnect from target system.
Notice
When you upload a cam from the SIMOTION device and have previously changed the
When you upload a cam from the SIMOTION device and have previously changed the
displayed cam, a window appears. You can accept the changed cam into the project via
the window. The cam is then uploaded from the SIMOTION device.