Roadmaster VRCD220S ユーザーズマニュアル

Basic

Operation

1. Turning the Unit On / Off
Press any button to turn the unit on,
WELCOME will be displayed on the LCD to
indicate it is ready for use. Press and hold
the POWER button to turn the unit off.

2. Mode Selection
Press the MODE Button to cycle between
AUX, RADIO and CD modes.

3. Volume
Use the VOL +/- Buttons to adjust the vol-
ume level. The higher the VOL number, the
higher the volume level.

4. Bass
Press the “SEL” Button until the display
shows “BAS”. Use the VOL +/- Buttons to
adjust. When DSP is ON, the Bass control
is not available.

5. Treble
Press “SEL” Button until the display shows
“TRE”. Use the VOL +/- Buttons to adjust.
When DSP is ON, the treble control is not
available.

6. Balance
Press “SEL” Button until the display shows
“BAL”, then use the VOL +/- Button to
adjust the balance between the left & right
speakers.

7. Fader
Press “SEL” Button five times and the
display shows “FAD”, then use the VOL +/-
Button to adjust the balance between the
front & rear speakers.

8. Clock
1. While listening to the radio, press the

“CLK” button until the clock is dis-
played

2. Press and hold the “CLK” button until

the time starts to flash

3. Press the VOL + Button to adjust the

hour

4. Press the VOL – button to adjust the

minutes

5. Press the “CLK” button again or just

leave the the unit idle for a few new set-
tings to take effect.

. DSP-Preset Equalizer Function

1. Press and hold the “SEL” button until

you hear a beep.

2. Press the “SEL” button to cycle through

the menu choices until you see DSP
OFF. 3. Press the +/- buttons to cycle
through the pre-set EQ settings.

4. Leave the unit idle for the new setting to
take effect.

10. Loudness
1. Press and hold the “SEL” Button until

you hear a beep.

2. Press the “SEL” Button until the display

shows “LOUD OFF”.

3. Use the +/- Buttons to select “LOUD

ON” (Loudness effect ON) or “LOUD
OFF” (Loudness effect OFF).

4. Leave the unit idle for the new setting to

take effect

11. Preset Beep Sound Off
1. Press and hold the “SEL” Button until

you hear a beep.

2. Press the “SEL” Button until the display

shows “BEEP ON”.

3. Use the +/- Buttons to select “BEEP

ON” (beep sound on) or “BEEP OFF”
(beep sound off).

4. Leave the unit idle for the new setting to

take effect.

12. Preset Volume Level
You can set the default volume level for the
unit when it is turned ON.
1. Press and hold the “SEL” Button until

you hear a beep.

2. Press the “SEL” Button until the display

shows “VOL LAST”.

3. Press the +/- Buttons to enter “VOL ADJ “

will be displayed.

4. Press the “SEL” Button and “A- VOL 15”

will be displayed. The number after A-
VOL indicates the volume level the unit
will default to the next time you turn the
unit ON.

DSP OFF POP M ROCK M

FLAT M CLASS M

VRCD220S English PROOF Manual.indd 10

10/15/08 11:34:18 AM