Proxim Tsunami MP.11 and MP.11a CPN 65755B ユーザーズマニュアル
Tsunami MP.11and MP.11a Installation and Management
Ethernet Port
To configure the Ethernet interface, click the Configure button, the Interfaces tab, and the Ethernet
sub-tab.
sub-tab.
You can set the following parameter from this tab.
Configuration
Select from the following settings for the type of Ethernet transmission (Configuration drop-down
box):
box):
10 Mbit/s – half-duplex
10 Mbit/s – full-duplex
10 Mbit/s – auto-duplex
100 Mbit/s – half-duplex
100 Mbit/s – full-duplex
autospeed-half-duplex
autospeed-auto-duplex
10 Mbit/s – full-duplex
10 Mbit/s – auto-duplex
100 Mbit/s – half-duplex
100 Mbit/s – full-duplex
autospeed-half-duplex
autospeed-auto-duplex
Half-duplex means that only one side can transmit at a time.
Full-duplex allows both sides to transmit.
Auto-duplex selects the best transmission mode for the given configuration.
Full-duplex allows both sides to transmit.
Auto-duplex selects the best transmission mode for the given configuration.
The recommended setting is auto-speed-auto-duplex.
MONITORING SETTINGS
The MP.11/a offers various facilities to monitor its operation and interfaces. Only the most significant
monitoring categories are mentioned here.
monitoring categories are mentioned here.
Chapter 4. Basic Management
38
CPN 65755
Issue Date: August 2003