Polycom QSX 3725-22370-001/B ユーザーズマニュアル
General Troubleshooting
System Problem
Corrective
Action
The system is not sending
content.
content.
The system is not connected
correctly.
correctly.
Ensure that all cables are
connected as shown in Setting up
the QSX System. If you are using
a VTX 1000 conference phone,
make sure that both the 8-wire
cable and conference link cable
are used to connect the QSX
system to the phone.
connected as shown in Setting up
the QSX System. If you are using
a VTX 1000 conference phone,
make sure that both the 8-wire
cable and conference link cable
are used to connect the QSX
system to the phone.
The system does not respond at
all.
all.
The system is not connected to
power.
power.
Ensure that the power supply is
connected to the system and to a
power source, that the power
cables are firmly seated, and that
the phone’s interface module is
connected to power.
connected to the system and to a
power source, that the power
cables are firmly seated, and that
the phone’s interface module is
connected to power.
A computer is connected to the
system but content does not
appear on the local VGA display.
system but content does not
appear on the local VGA display.
The system is idle or the QSX
system base is not receiving a
VGA signal from the computer.
system base is not receiving a
VGA signal from the computer.
Press the Content button on the
content controller, or the
PREVIEW soft key on the VTX
1000 conference phone, until you
see a preview on the local VGA
display.
Press the appropriate function
keys, such as <F5>, on the
computer to send a VGA signal
out.
content controller, or the
PREVIEW soft key on the VTX
1000 conference phone, until you
see a preview on the local VGA
display.
Press the appropriate function
keys, such as <F5>, on the
computer to send a VGA signal
out.
The conference phone does not
have a dial tone.
have a dial tone.
The system is not connected
correctly.
correctly.
Ensure that all cables are
connected as shown in Setting up
the QSX System. The conference
phone’s floor/wall module must
be connected to a POTS (analog
phone) outlet.
connected as shown in Setting up
the QSX System. The conference
phone’s floor/wall module must
be connected to a POTS (analog
phone) outlet.
The SoundStation VTX 1000
conference phone does not
display the correct QSX soft keys.
conference phone does not
display the correct QSX soft keys.
The SoundStation VTX 1000
conference phone has software
earlier than version 1.6.
conference phone has software
earlier than version 1.6.
Update the SoundStation VTX
1000 conference phone to use
software version 1.6 or later.
1000 conference phone to use
software version 1.6 or later.
The indicators on the front of the
QSX base are flashing red and
green.
QSX base are flashing red and
green.
The system is in Boot UI mode.
Start SoftUpdate to update the
QSX system software, or
disconnect the power cord and
reconnect it to restart the system.
QSX system software, or
disconnect the power cord and
reconnect it to restart the system.
How to Contact Technical Support
If you are not able to make test calls successfully and you have verified that the
equipment is installed and set up correctly, contact Polycom Technical Support by
telephone or Internet as described below.
equipment is installed and set up correctly, contact Polycom Technical Support by
telephone or Internet as described below.
46