Topfield Water System v2.0 ユーザーズマニュアル
v2.0 user guide
Page 19
Note that this time applies to the recording from the next full hour after it finishes. That
is to say, if a pattern has an expiry time of 1 day 3 hours, and a programme finishes
recording at 1.25pm on a Tuesday, then the next full hour is 2pm, so it will be
automatically deleted 1 day 3 hours later at 5pm on the Wednesday.
is to say, if a pattern has an expiry time of 1 day 3 hours, and a programme finishes
recording at 1.25pm on a Tuesday, then the next full hour is 2pm, so it will be
automatically deleted 1 day 3 hours later at 5pm on the Wednesday.
Use [LEFT/RIGHT ARROW] to change the time in units of one hour, or [CHANNEL
UP/DOWN] to change it in units of one day. The default is never.
UP/DOWN] to change it in units of one day. The default is never.
8 . The Recording/Timer edit screen
iGuide’s timers are created with a default set of attributes,
which can be edited as necessary in this screen. A recording
or timer can be edited by selecting it in the recordings/timers
screen, and then pressing [PAUSE].
which can be edited as necessary in this screen. A recording
or timer can be edited by selecting it in the recordings/timers
screen, and then pressing [PAUSE].
The following keys are available in recording edit mode:
[RED]: After confirmation (by pressing [YELLOW] – any other key cancels) deletes
the recording/timer and exits.
the recording/timer and exits.
[YELLOW]: Saves the current state of the recording and exits
[BLUE]: Exits without saving
[BLUE]: Exits without saving
The available options for edit are:
TITLE: The title of the recording. Press [OK] to enter edit mode to change the text.
CHANNEL: Specifies the channel on which the recording/timer was/will be recorded.
Use [LEFT/RIGHT ARROW] to change.
Use [LEFT/RIGHT ARROW] to change.
DATE: The date on which the recording is to be made – use [LEFT/RIGHT ARROW]
to change in units of one day.
to change in units of one day.
PERIOD: The time at which the recording is to start and end. Use [OK] to switch
between the two, [LEFT/RIGHT ARROW] to adjust in units of one minute, or
[FFW/REW] to adjust in units of 15 minutes.
between the two, [LEFT/RIGHT ARROW] to adjust in units of one minute, or
[FFW/REW] to adjust in units of 15 minutes.
FOLDER: Specifies the folder into which the recording will be placed. Use
[LEFT/RIGHT ARROW] to cycle through the list of existing folders; [OK] to enter edit
mode to create a new folder; or [SLOW] to create a new folder (or find an existing one)
from the recording’s title. If a folder specified here does not exist, it will automatically
be created when the recording is saved, or forgotten about if the changes cancelled.
[LEFT/RIGHT ARROW] to cycle through the list of existing folders; [OK] to enter edit
mode to create a new folder; or [SLOW] to create a new folder (or find an existing one)
from the recording’s title. If a folder specified here does not exist, it will automatically
be created when the recording is saved, or forgotten about if the changes cancelled.
EXPIRES: Specifies the specific time and date that the recording will be deleted. This
defaults to never. It cannot be earlier than the current date and time. Use [LEFT/RIGHT
ARROW] to change the expiry time in units of one hour, or [CHANNEL UP/DOWN] to
change it in units of one day.
defaults to never. It cannot be earlier than the current date and time. Use [LEFT/RIGHT
ARROW] to change the expiry time in units of one hour, or [CHANNEL UP/DOWN] to
change it in units of one day.