OTC Wireless WIJET.G 802.11G ユーザーズマニュアル

WiJET.G Technical Manual 

 

24

 
5.1  Unable to Connect or Establish a Session with WiJET.G 

If you could not establish a session with WiJET.G(s) and get a message box indicating 
no WiJET.G is available for connection or no WiJET.G is found, the possible causes 
are listed below.   

 

1)  The SSID of the wireless adapter is not set up to be the same as the 

WiJET.G’s.   

2)  The computer’s Wi-Fi Adapter is not set to Infrastructure Station mode. 
3)  The computer’s Wi-Fi Adapter is not set to use the same encryption 

settings as WiJET.G, if WiJET.G’s default encryption settings were 
changed. 

4)  The WiJET.G is somehow not receiving the wireless signal, power-cycle 

the WiJET.G. 

5)  Some DHCP-enabled wireless network connection client may take a 

while to obtain a valid OS-assigned IP address. You can use “ipconfig” 
command to see whether a valid IP address has been assigned or not to 
the corresponding network connection. 

6)  With certain brands of PCMCIA 802.11g Wi-Fi cards, it might take a bit 

longer to link up with the WiJET.G than with other brands of PCMCIA 
cards.  The reason for this is that the drivers and features set of each 
brand might cause the link up time between the WiJET.G and the 
computer to take longer.  Simply try to establish a session again.  If the 
same issue persists, there probably is no link established between the 
WiJET.G and the computer. 

 

This indicates that WiJET.G has detected a link-loss. WiJET.G and WiJET.G PSM have 
an intelligent built-in mechanism to detect the link-loss and can automatically restore 
the connection by coordination. When a link-loss has been detected, WiJET.G PSM 
displays a message box and trying to automatically restore the connection. If the auto-
reconnection attempt is successful, user does not need to do anything. In this case, the 
auto-reconnection is user transparent. However, if the cause to the link-loss is due to 
physical disconnection, for instance, the PCMCIA card was pulled out,  user needs to 
restore the physical connection so that the auto-reconnection attempt can succeed. 
The presentation screen won’t be updated once the link is lost,  unless a reconnection 
is re-established. However, if link-loss stays for an extended period, the WiJET.G will 
terminate the reconnection waiting state and display the banner page indicating that a 
fresh presentation session is ready for being established.  
 
The default duration for a link-loss is 8 seconds.  WiJET.G will retry 3 periods of this 
duration. If no re-connection is established before the reconnection time running out, 
WiJET.G returns itself to the banner page.