Oricom CARE90 ユーザーズマニュアル

4

Installation

Desk  Mounting

Fit the bracket as shown in the illustration. 

Insert the brackets three tabs into the 

matching slots on the bottom of the phone 

and click  into place.

1. Fit the bracket as shown in the illustration. 

Insert the brackets three tabs into the 

matching slots on the bottom of the phone 

and click into place.

2. Drill two holes vertically, one above the

other, 83mm apart, and leave the screws 

protruding from the wall by 5mm.

3. Turn around the hanging peg (located by the hook switch) for 180 

degrees, so it will hold the handset in place when the phone is 

mounted on the wall.

4. Position the mounting holes on the base of the phone over the two 

protruding screws on the wall plate or on the wall. Gently push the 

phone flush against the wall plate then slide the phone downwards 

locking it into place.

1. Plug one end of the curly cord into the socket on the handset.
2. Plug the other end of the curly cord into the left side of the phone.
3. Plug one end of the telephone line cord into the jack at the back of the 

base, and the other end into the wall socket.

4. Pick up the handset and listen for dial tone.

NOTE:
In Australia some phone wall sockets are the old “non modular” style.
If you have this type of wall socket you will need to purchase a 

modular converter plug” (not supplied). These can be obtained from 

electronic stores.

Bracket position 
for desk mounting

Bracket position 
for wall mounting