Oregon Scientific EMR211 オーナーマニュアル

4

 NOTE  Use alkaline batteries for longer usage and consumer 

grade lithium batteries in temperatures below freezing.

1. Press   or   to select among 5 different outdoor 

channels of remote sensors.

2.  Press and hold   for 2 seconds to enforce 

researching for the selected sensor.

To auto-scan among sensors:
•   Press and hold   for 2 seconds to enable auto-scan 

function for all 5 channels. The temperatures will be 
displayed automatically in sequential order (Channel 
1,2,3,4,5)

Main unit is searching for 

sensor(s).

A channel has been found.

The sensor cannot be found.

 TIP  The transmission range may vary depending on 

many factors. You may need to place the sensor(s) in 

different locations to get the best result(s). 

To select temperature unit:
•   Press 

SET to select °C or °F for temperature readings. 

 If the channel 1 sensor falls from 37°F 

to 28°F (3°C to -2°C), LED indicator in the front of the 

main unit will flash continuously, and will stop flashing 

once the temperature is out of this range.

•   Press   and   at the same time to deactivate the 

ice alert warning. 

•   The ice alert warning will be disable/enable again 

when the temperature falls again from 37°F to 28°F 
(3°C to -2°C).

 NOTE  As ice alert is only applicable to channel 1, to 

prevent flashing of LED, select channel 2-5 on outdoor sensor.

Press 

RESET at the rear of the main unit to return to 

the default settings.