Juniper Networks IDP 800 ユーザーズマニュアル

Management Ports 

„ 

13

Chapter 2: Hardware Overview

After peer port modulation (PPM) is enabled, the sensor deactivates all the 
interfaces in that virtual router if the link goes down for any of the interfaces in a 
virtual router. All devices connected to the virtual router will detect a port failure 
and must be configured to take appropriate action.

You cannot enable NIC bypass and PPM on the same sensor. On the IDP 75, 250, 
800, and 8200 sensors:

„

PPM works on both copper and fiber interfaces.

„

PPM works by turning off appropriate interfaces. Because of this, interface 
speeds can be set to auto on the sensor and on attached switches.

Management Ports

These ports are provided on all IDP sensors.

Console Serial Port

The console serial port provides access, using an RJ-45 connector, to the sensor’s 
command-line interface (CLI).

Management Port

The management port provides access to the ACM to the sensor through 
10/100/1000 Mbps Ethernet. The ACM is accessed from the management port and 
entering the correct URL in a browser window (

https://SensorIPAddress)

. 

Hard Drives and USB Ports

Table 5 describes the hard drives and USB ports available on each sensor.

Power Supplies

Table 6 describes the types of power supplies available on each sensor.

NOTE: 

Although both the console serial port and the management port use RJ-45 

connectors, do not plug the network cable into the console serial port.

Table 5:  IDP Sensor Drives

IDP Sensor

Drives

75, 250

„

One USB port

„

One internal hard drive

800, 8200

„

One USB port

„

Two externally accessible, hot-swappable, RAID-1 
mirrored hard drives