Motion Computing M1300 取り扱いマニュアル

Chapter 4  Using Your Motion Tablet PC

Motion Computing Tablet PC User Guide 51

To set up a password to access the PhoenixBIOS

TM

 Setup Utility 

on the Tablet PC:

NOTE: These procedures describe using the Pen to enter information; you can 
also attach an external keyboard if you prefer.

1. Start the Tablet PC.
2. When the Motion Computing Splash Screen appears, 

quickly press Hot Key #2 (icon shown here). If you 
miss the Splash screen, turn the Tablet PC off then back 
on and try this step again.

3. From the PhoenixBIOS Setup Utility, tap Security on the menu bar.
4. To set up a System password, double-tap Enter next to Set 

System Password.

5. Type in a System Password using the onscreen keyboard. 
6. Tap Enter.
7. Type in the password again to confirm it. 
8. Tap Enter. The system returns to the Security screen and the System 

Password reads Set. A password is now required to enter the 
PhoenixBIOS Setup Utility.

9. To set up a Password on boot, tap Disabled next to Password on 

boot until Enabled is highlighted. You will not be prompted to type 
in another password because Password on boot uses the System 
password. 

NOTE: You cannot set up Password on boot until you set up a 
System password.

10.If you have finished setting up a password, tap Exit or press the Esc 

key on the Tablet PC to exit the PhoenixBIOS Setup Utility.

11.When you exit, you’re prompted to select from the 

following options:
• Exit Saving Changes
• Exit Discarding Changes
• Load Setup Defaults
• Discard  Changes
• Save Changes

12.Select the desired action.
13.Confirm the selection by tapping Yes.

To set up a password to start the Tablet PC (so no one can access the 
information on the Hard Disk Drive of your Tablet PC even if it’s 
removed and installed in another Tablet PC without the proxy 
password):

1. Start the Tablet PC.