Microplane 901 ユーザーズマニュアル
5
ANALOG INPUTS The 901 provides both balanced and unbalanced inputs. Input
connections are made using the female XLR connector on the rear panel. These
connectors are wired with pin 2 positive, pin 3 negative and pin 1 ground. The unbalanced
phono type jacks are wired in parallel with pin 2 of the XLR balanced jacks. Connecting
unbalanced and balanced signals simultaneously is not recommended.
connections are made using the female XLR connector on the rear panel. These
connectors are wired with pin 2 positive, pin 3 negative and pin 1 ground. The unbalanced
phono type jacks are wired in parallel with pin 2 of the XLR balanced jacks. Connecting
unbalanced and balanced signals simultaneously is not recommended.
Model 901
Specifications
GAIN
Normal Mode
-
∞
to +10dB
Boost Mode
-
∞
to +20dB
FREQUENCY RESPONSE
@ 0dBu out +/- .25dB
@ 0dBu out +/- .25dB
22Hz - 120kHz
@ 0dBu out +/- .5dB
12Hz - 260kHz
@ 0dBu out +/-3dB
4Hz - 600kHz
MAXIMUM OUTPUT LEVEL
@ 1kHz, 50 Ohm load
@ 1kHz, 50 Ohm load
+23dBu (10.9Vrms, 30.8V p-p)
INPUT IMPEDANCE
40K Ohms balanced
20K Ohms unbalanced
OUTPUT IMPEDANCE
5 Ohms
5 Ohms
DYNAMIC RANGE
@ 0dB gain, 50 Ohm load
@ 0dB gain, 50 Ohm load
116dB
@ -10dB gain, 50 Ohm load
121dB
CMRR
3.5Vrms in, 10dB gain
3.5Vrms in, 10dB gain
>75dB
DISTORTION
THD+N
10dB gain, +10dBu out, 50 Ohm load
THD+N
10dB gain, +10dBu out, 50 Ohm load
0.0051%
SMPTE
4:1 10dB gain, +10dBu out, 50 Ohm load
4:1 10dB gain, +10dBu out, 50 Ohm load
<0.012%
ATTENUATOR CHANNEL MATCHING
<0.05dB
D\A SPECIFICATIONS
Input sample rate
Input sample rate
44.1, 48, 88.2, 96kHz
Input word length
16 to 24 bits
THD+N
44.1kHz, 24bit, 1kHz, +20dBu out
44.1kHz, 24bit, 1kHz, +20dBu out
0.0016%