Hitachi Car Video System lcd monitor ユーザーズマニュアル
17
EN
GLISH
1. Mount the side input into the speaker holder.
Hook the clamps (4 pieces) of the speaker holder into the holes as shown in the figure and pull them down until it sounds click.
Fasten the side input with the speaker holder by the accessory screw.
Fasten the side input with the speaker holder by the accessory screw.
Refer to
about the connection of side input.
See the below figure how to treat the cable.
Make sure to secure the power cable and the connecting cables for other audio visual devices, except the speaker connecting
cables, to the clamps and the cable strap of the monitor stand and the rear of it. When the monitor is swiveled, the connectors may
drop out and generate heat. It could cause fire and/or connector failures.Moreover, when wiring up and securing these cables, give
suitable slack not to rub the stand during swiveling or not to block the action of swivel.
cables, to the clamps and the cable strap of the monitor stand and the rear of it. When the monitor is swiveled, the connectors may
drop out and generate heat. It could cause fire and/or connector failures.Moreover, when wiring up and securing these cables, give
suitable slack not to rub the stand during swiveling or not to block the action of swivel.
INSTALLATION INSTRUCTIONS (continued)
Mounting the Side Input
13
Side input
Screw X 1
(Included with side input)
(Included with side input)
2. Mount the side input into the holder on rear of the monitor.
Fasten the side input with the holder by the accessory screw.
See the below figure how to treat the cable.
See the below figure how to treat the cable.
Speaker Holder
Side Input cable
Side Input cable
Cable strap
Bundle the cables
to be secured
to be secured
Power cord
Connecting
cable
cable
[An example of treating the cables]
CAUTION