Compex Technologies WP11A+ ユーザーズマニュアル
Chapter 8
Configuration on Various WAN Type
44
Chapter 8
Configuration on Various WAN Type
This section explains how to configure the Compex WP11A+ as a Wireless Broadband Internet
Gateway to distribute Broadband Internet Access to a wireless network.
Gateway to distribute Broadband Internet Access to a wireless network.
Besides Dynamic IP connection, Compex WP11A+ also supports Static IP, PPP over Ethernet,
Singapore ADSL (Ethernet 512K) and Australia BPA Cable.
Singapore ADSL (Ethernet 512K) and Australia BPA Cable.
If you have chosen self-installation when you register for your broadband service, you should
first test the ADSL modem together with the logon account on your PC or notebook. Ensure that
it can connect successfully before attempting to run it with Compex WP11A+.
first test the ADSL modem together with the logon account on your PC or notebook. Ensure that
it can connect successfully before attempting to run it with Compex WP11A+.
For simplicity and illustration purposes, it is assumed that the following LAN environment uses
the IP address 192.168.168.xxx and Compex WP11A+ is using the default settings.
the IP address 192.168.168.xxx and Compex WP11A+ is using the default settings.
However, if you have assigned a different IP address for Compex WP11A+, then use the new
settings in the setup procedures.
settings in the setup procedures.
8.1
Configuring Static IP Connection
1. Go to WAN setting at Command Window, click on the “Change” button and check
the radio button next to the Static IP Address.
2. Click on “Save” button to update the data.
Figure 8.1a
Select WAN Type - Static IP Address