Fisher & Paykel 80078 プリント

I N S T A L L A T I O N   I N S T R U C T I O N

P R O D U C T   D I M E N S I O N S

MODEL NUMBER   80078   RH900CB.

BULB

I N S T A L L A T I O N   O P T I O N   A C C E S S O R I E S

Electrical Rating:
372W (1.55A)
Max. at 230-240V 50Hz

320mm

900mm

72mm

280mm

104835 issue B
ECN 05 048

 MANUFACTURED FOR

BY:

Left Push Button

=     Light On/Off Switch

Second Push B

utto

n

=     Fan On High Speed

Third Push Button

=     Fan On Second Speed

Fourth Push Button

=     Fan On Low Speed

Fifth Push Button

=     Fan Off

CONTROL PANEL

LIGHT REPLACEMENT

a) Halogen bulb 12Volt/20Watt required.
b ) Switch off the power to rangehood.
c ) Use  a  small  bladed  screwdriver  to  prise  off  the  light  cover.
d ) Use  a  cloth  to  remove  the  bulb.    Do  not  touch  the  bulb  with fingers.
e ) Replace with a new bulb using a cloth.  Do not touch the bulb

with fingers.  Snap the cover back in place.

For other accessories, parts or service, please contact your local supplier (Refer to Warranty Certificate).

      

DUCTED

        RECIRCULATED

       UNIDUCT FLEXI DUCT KIT is recommended.           Use manufacturer Product Code.
       1569 Flexi Duct Kit (150mm)

          1744 Recirculation Kit

For other accessories, parts or service, please contact your local supplier or approved service agent

MAINTENANCE
Particular care should be taken with grease filter which must be periodically cleaned (at least
every two months). Remove the grease filters and wash them either by hand or in the
d i s h w a s h e r   u s i n g   m i l d   d e t e r g e n t .   C a u t i o n :   N e v e r   u s e   p r o d u c ts   c o n ta i n i n g   a b r a s i v e s
(e.g. scouring pads, steel wool, abrasive liquid cleaner etc.) Use lukewarm water and a mild
detergent to clean stainless steel components. In high humidity and coastal environments,
cleaning should be carried out more frequently.

WARNINGS
• Care should be taken when removing filters in order to prevent the filter falling and causing

damage to the hob top.

• This appliance is not intended for use by young children or infirm persons without supervision.
• Young  children  should  be  supervised  to  ensure  that  they  do  not  play  with  the appliance.
• Upon  installation  the  appliance  must  be  positioned  so  that  the  plug  is accessible.
• There should be adequate ventilation of the room when the rangehood is used at the same time as

appliances burning gas or other fuels.

• You  must  read  the  details  concerning  the  method  and  frequency  of  cleaning.
• There is a fire risk if cleaning is not carried out in accordance with the instructions.
• Do not flambé under the rangehood.
• Exhaust  air  must  not  be  discharged  into  an  existing  flue  used  for  exhausting fumes from

appliances burning gas or other fuels.

• The recomended minimum distance between the hob surface and the lowest part of the range-

hood is 600mm. This should be increased to at least 650mm if installed over a gas hob.
We recommend 700mm.

• Attention should be given to ensure that any applicable regulations concerning the discharge

of exhaust air is fulfilled.

• If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer

or  it’s  service  agent,  or  a  similarly  qualified  person  in  order  to avoid a hazard.

525mm (min) to 725mm (max)

500mm