BMW 2006 M6 Coupe オーナーマニュアル

 183

procedures with correspondingly trained per-
sonnel. Due to the high voltage involved, there 
is a danger to life and limb when work is carried 
out improperly.

<

The illustration shows the front left side of the 
engine compartment.

Bulb 55 watts, H 7

1.

Remove the cover cap

1 by pressing the tab 

and removing the cover cap upward.

2.

Press the bulb holder from above to release 
it.

3.

Remove the bulb holder.

4.

Remove and replace the bulb.

The lamp H7 is pressurized; wear eye 
protection and protective gloves. Other-

wise there is a danger of injuries if the bulb is 
accidentally damaged during replacement.

<

Bulb 10 watts

Bulb holder and reflector are one unit and 
are replaced together.

<

1.

Turn the bulb holder

2 to the right and 

remove.

2.

Press the snap connection on the plug con-
nector, pull off the bulb holder and replace.

Your BMW is equipped with two turn signal 
lamps per side in the front.

Bulb 21 watts, WY 21 SV
The illustration shows the front right side of the 
engine compartment.

1.

Press the lever shown:

>

downward for the right turn signal

>

upward for the left turn signal

2.

Remove the bulb holder towards the rear.

3.

Remove and replace the bulb.

Bulb 21 watts, WY 21 SV
The bulb for the turn signal lamp 2 can be 
replaced via the wheel well.
The illustration shows the front left side of the 
vehicle.

1.

Steering turned all the way to the left or 
right.

2.

Turn off the light, switch off the ignition and 
remove the remote control from the ignition 
lock.

3.

Unscrew the bolt 

1 with the open-ended 

wrench from the onboard toolkit, refer to 
page

.

Online Edition for Part No. 01 41 0 012 118 - © 02/06 BMW AG