Zoom H2 ユーザーズマニュアル

ページ / 94
 
ZOOM H2
 
89
 
Error Messages
 
Card related messages
Cause
Remedy
 
No Card
 
No SD card is inserted.
Insert SD card and turn power on.
 
No File
 
A valid file was not found.
 
Card Format Error!
 
SD card formatting process failed, or card 
was not recognized normally.
*
 
Card Full!
 
Card became full during recording
 
File name exists!
 
File name change was attempted, but file 
with same name already exists.
Specify a different file name.
 
Stop Recorder!
 
User attempted to access a menu not 
available during playback or recording.
Stop the recorder operation first.
 
Card Protected
 
The SD card is write-protected.
Change setting of card's write-
protect switch.
 
Format Card?
 
SD card with incorrect format was inserted.
When you select "YES" at this 
screen and then press the 
 
5
 
 (REC) 
key, all data are erased and 
initialization is carried out.
 
Now Recording!
 
User attempted to access a menu not 
available during recording or recording 
standby.
Stop recording first.
 
File Create Error!
 
The file could not be created at start of 
recording.
*
 
Card Error!
 
A card error has occurred.
 
File Protected
 
User attempted to write to a read-only file 
from the file menu.
Change the read-only file attribute 
using a computer.
 
File Rename Error!
 
A blank or invalid file name was specified 
during file name editing.
Do not use invalid characters.
 
Card Write Error
 
Shown when an error occurs during file 
write other than recording.
*
 
Card Read Error!
 
Shown when an error occurs when opening a 
file.
 
Data Write Error
 
Shown when data transfer to SD card cannot 
keep up with data stream during recording.
Reduce sampling frequency and/or 
number of bits.
 
* If card related error messages occur frequently, the SD card may be defective.
 
Other messages
Cause
Remedy
 
RESET DATE/TIME
 
The internal clock was reset because battery 
backup was interrupted.
Set the date and time again. The 
internal clock requires batteries to be 
inserted.
 
Low Battery!
 
Battery voltage is low.
Replace batteries.
 
Please Power Off
 
Shutdown procedure is complete.
Set power switch to OFF.
 
Please pull out external input
 
When external mic or component is 
connected, mic pattern cannot be selected.
Disconnect any external mic or 
component connected to [EXT MIC 
IN] or [LINE IN] jack.
 
Only Built-in MIC is active
 
External mic or component is connected, 
although only built-in mic is active in 4-
channel mode.
 
Invalid File!
 
An invalid file was specified.
Select a valid file.
H2-E.fm 89 ページ 2007年7月11日 水曜日 午後3時19分