Zhone 08-01002-01 ユーザーズマニュアル

Installing the Elite Modem   1-5

Revision 2.01

Elite Modem Installation Guide  

08-01002-01

Task:
Installing the Modem

Note: Some computers require an adapter between the RJ-45 
Ethernet cable and the Ethernet connector on the back of the 
computer (the adapter is often a round, 8-pin connector).

Make sure that all of your Elite Modem equipment is available before 
proceeding.

Connect the RJ-45 Ethernet cable to the 10Base-T Ethernet Card connector 
on the rear of your computer. Connect the other end of cable to the Ethernet 
port on the rear of the modem labeled: To PC.

Your telephone is connected with an RJ-11 modular phone line cord to a 
telephone wall jack. Disconnect the telephone line cord from the telephone 
wall jack and insert it into the jack in the rear of the modem identified with this 
icon:

Connect the RJ-11 modular phone cord to the connector on the rear of the 
modem labeled, To Wall Jack. This connector is identified with a telephone 
line symbol.

Insert the other end of the phone cord into the telephone wall jack.

Connect the rounded plug end of the power supply cord into the 5V AC 
connector on the rear of the modem. 

Plug the power supply into wall outlet. This completes the modem physical 
installation. Proceed to Setup. At this point, the Power and the Loop Status 
indicator lights should be green. 

Note: See “Modem Indicators” on page 1-6 for more information on the Elite 
modem LED indicators.