Vogelzang International Defender High Efficiency Air-Tight Woodstove TR001 ユーザーズマニュアル

VGZ-026 / 052705.1 

TR001 DEFENDER™

 / 

1. Uncrate the stove and remove cardboard pack-

ing and protective poly bag.

2. Remove four (4) legs and hardware pack from

inside stove. NOTE: Stove may be lightened
during installation by removing fire brick. Re-
place firebrick before using. There are three
different sizes brick. Note the location of each
while removing or refer to illustration 1 for
proper location inside firebox.

3. Place flattened carton on floor and lay the stove

on it’s back.

4. Remove the four 14mm nuts from the threaded

studs located on each corner (total of 16).

5. Place leg in position and secure using the nuts

removed in step #4. Tighten nuts securely.

6. Carefully lift the stove into an upright posi-

tion.

7. Cut and remove wire tie holding “Z” bar in

place. The “Z” bar is located at the top front
inside of stove. The plastic wire tie is for ship-
ping purposes only.

8. Level stove with adjustable glides on bottom

of legs.

1. Attach blower assembly (#3) to back of rear

deflector. NOTE: Make sure ceramic gasket is
positioned between rear deflector heat shield
and blower assembly. Use four screws provided
to fasten the blower to rear heat shield.

2. Route the power cord away from stove. Do not

allow the power cord to touch any hot surfaces.
Keep power cord at least 12˝ from stove sur-
faces.

3. Once stove is positioned, plug power cord into

a grounded 120v outlet.

1. The stove must be placed on solid concrete,

solid masonry, or when installed on a combus-
tible floor, on a listed floor protector, such as
Hy-C or Imperial Model UL 3648BK or
equivalent with 0.08 R factor. (NOTE: to cal-
culate R-value of alternative materials see page
17). The base must extend at least 18” beyond
the front of the access door, 8” to the sides of
fuel opening, and must  extend under and 2
inches beyond either side of the stove pipe if it
is elbowed towards a wall. (See figures 1 & 3
and consult local building codes and fire pro-
tection ordinances). A grouted ceramic floor
tile installed per local building code is consid-
ered a durable equivalent.

2. The stove must have its own flue. DO NOT

3. After observing the clearances to combustible

materials (figures 1–3), locate your floor
protector accordingly (figure 1) and carefully
place the stove in your selected location.
Install stove pipe, elbows, and thimble as
required, utilizing either a recently cleaned and
inspected 6”  masonry chimney or a 6” i.d.
listed chimney.