Revox M208 ユーザーズマニュアル

M208 

   Re:control 

 

K-1 

K Appendix 
 

 
 
 
 
 
 
 
 
 
 
 
 

No LCD display when 

unit is touched 

 

Check the batteries and replace if necessary 

 

Check that the batteries are in the right way round 

 

Activate the movement sensor through the Setup Menu 

Backlighting remains 

dark 

 

Activate backlighting in the Setup Menu  

 Backlight 

 

Is the brightness sensor covered? 

 

Is the ambient light too bright?   Setup Amb. Light 

Display shows Card? 

when a button is 

pressed 

 

MMC memory card is not installed correctly or it is missing. 

See Chapter MMC Card. You are not using an original 

MMC card from Revox. 

Synchronisation with 

the M51 cannot be 

carried out 

 

The connection through the M208 Link interface is faulty. 

See Chapter Synchronisation. 

 

The M51 does not have the software that is needed to carry 

out a synchronisation. See Technical Data.  

A mechanical noise can 

be heard from the M208

 

There are two gold bearings in the M208’s movement 

sensor that move against each other. This can be heard in a 

very quiet environment and does not signify a fault. 

The device to be 

controlled does not 

respond to the infrared 

command 

 

With some M208 sources, not all buttons send infrared 

codes. Please check in the Operating manual of the 

corresponding device(s) to see whether the buttons send 

infrared codes (grey border).  Additionally, the display 

shows the symbol    top right, if an infrared code is being 

sent. 

 

The device cannot receive the infrared code because it is 

too far away or because the transfer angle is too large. Try 

again while standing nearer to the device and/ or hold the 

remote control directly in front of the device.