Torker Bicycle DX プリント

1.

 

Determine the front, back,

right and left of the unicycle and

the wheel. Set the wheel into

the bearing cradles. Place the

bearing caps [A] in place and

tighten the bolts to 45 inch

pounds [B]. Do not over tighten

[C]. Spin the wheel and check

the spokes. Adjust if needed.

2. Apply a small amount of

grease to the pedal threads.

Thread the pedals into their cor-

responding crank arms [D1] =

L-pedal to L-crank. [D2] = R-

pedal to R-crank. Tighten se-

curely w/ a 15mm wrench. This

is also a good time to check the

crank arms and tighten them

if necessary.

3. Slide seatclamp on top of fork

[F]. Apply a thin film of grease

to the seatpost and insert it into

the fork [G]. Using the 5mm

allen wrench, tighten the

seatpost clamp so that the

seatpost does not twist in the

fork [H]. Also check that the

bolts holding the seat onto the

post are secure, as well as the

bolts on the handle.

4. Make sure the tire bead is

seated evenly on the rim.

Inflate the tire to the recom-

mended pressure that is printed

on the sidewall of the tire.

With proper setup and care, your new Unistar will provide

years of fun and entertainment.

Please read this manual thoroughly and save it for future reference. If

you have any doubts about your ability to assemble or adjust your uni-

cycle, please contact your local bicycle dealer for assistance.

: Unicycles have a “front”, “back”,

“left” and “right”. It is important to know this to en-

sure that the saddle and pedals are installed correctly.

The fork is slotted where the seat post is inserted.

This slot is on the “back”. The UNISTAR decal on the

tube is on the “front.”

Align the saddle so that the narrow end or the handle

(depending on the model) is pointed forwards. Make

sure the seat post is tight in the fork, as this is

crucial in controlling and steering your unicycle.

Cranks and pedals are marked

left and right; with a “L” and “R” stamped in to them.

Make sure the cranks are on the appropriate sides.

The pedals can only be installed in their respective

cranks arms. The

right pedal tightens

clockwise and the left

pedal tightens

counter-clockwise.

The pedals must be tight in the cranks! This

helps to prevent the pedals from loosening

during riding.

: Always wear a

helmet when riding your unicycle. We also recommend

knee pads, elbow pads, and wrist guards, especially if

you are new to unicycle riding.

Make sure all parts are tight and adjusted properly and

that the tire is inflated to the recommended pressure. NEVER

ride any unicycle if any parts seem loose, cracked, broken or out of

adjustment. And when riding, please avoid traffic and busy areas.

Never ride beyond your ability. Take responsibility for your actions. You

are encouraged to ask your local bicycle retailer about unicycling. There

are also a number of unicycle-related resources available on the Internet,

including clubs and instructional materials.

Your Unicycle Box

should include all of these parts.

You will need

these tools to

assemble your

Unistar.

** 

Wheel w/Cranks & Tire

Saddle w/Post

Seatclamp

Bearing

Caps

Clamp

Hardware

Pedals

Unistar

Fork

4-5-6

“Y” allen

wrench

15mm wrench

or 15mm Pedal Wrench

10mm open

end wrench

10mm Allen Wrench