Ovation Software Label Printer ユーザーズマニュアル

Getting Started

6

Ovation



2

 

 

 

1. Open the cover.

 
 

2. Push the printhead latch toward the back of the printer and raise

the printhead carrier assembly.

 
 

3. Place a roll of media (labels should be facing up) on the media

hub and insert into the printer.

 
 

4. Pull the Peel-off Lever forward to the ‘open’ position.

 
 

5. Remove 6

″

 (152 mm)of  labels from the backing. Route the

backing over the tearbar and behind the peel-off shaft as shown
below.

 

 
 

              Figure 1-6   Loading Media for Peel Configuration

 

 

 

 

6. Push the Peel-off Lever back to the ‘closed’ position

 
 

7. Close the printhead carrier assembly and press down until it locks

into place.

 
 

8. Close the cover and press the ‘feed’ button two or three times to

feed the media and ensure proper tracking. The labels will
separate automatically as it is feed through the printer.