NDC comm NWH650 ユーザーズマニュアル
InstantWave
High Rate
11Mbps
Access Point
21
Figure 15. New Entry
Two levels of access are available.
Read
Read-only rights. The user may read everything
except the Access Control settings, but cannot
alter anything
except the Access Control settings, but cannot
alter anything
Read/Write
The user may read and alter all settings
Enter your IP address and then set your own access rights to Read/Write (see the
following note).
following note).
Note: Do not set all the stations in the Access Control table to Read. Once this is
set and enabled, it will be difficult to modify the AP. Should this situation
occur, use the AP COMFig utility to reset the configuration.
occur, use the AP COMFig utility to reset the configuration.
To set a stations access rights, enter a station’s IP address and community string
(the community string is used as a password to access the AP) and choose Read or
Read/Write.
(the community string is used as a password to access the AP) and choose Read or
Read/Write.
When all the settings are made, click OK to return to the Access Control card. On
the Access Control card, click the Apply button to make the changes effective
immediately, without closing the dialog box, or click OK to accept the changes and
close the box.
the Access Control card, click the Apply button to make the changes effective
immediately, without closing the dialog box, or click OK to accept the changes and
close the box.
Perform AP Self Diagnostic Test
On the Service card, click Perform AP Self Diagnostic Test. The Hardware
Diagnosis screen will open (Figure 16).
Diagnosis screen will open (Figure 16).