Frymaster Heated Landing Zone HLZ ユーザーズマニュアル

 
 

 

 

5

 

HLZ Computer. 

5.1  Programming Temperatures 
 
You are able to program the setpoint temperature of both the air heater and the heater plate via the computer 
interface.  The heater plate factory default is set to the McDonald’s standard of 160

°F.  The air heater factory 

default is set to the McDonald’s standard of 220

°F.  If the factory default temperature settings are acceptable, skip 

to Section 7.2, Page 6. 
 
Ensure that the HLZ computer is in the OFF position (nothing in the display).   
Press 

, then enter 1, 2, 3, 3.  Use the numerals in the upper right-hand corner of each key. 

 
 

Press 

, then 

, 

, 

, 

. 

 
 
The display will read SET and the LEDs on both the Heater Plate button (1) and the Air Heater button (4) will 
light (see previous diagram, HLZ Computer).  Press the button that corresponds to the heater you wish to 
program. 
 
Press the Up and Down Arrow Keys to achieve the desired set-point temperature, then press the Check button 
once.  Both heater LEDs will again light.  
 
 

Press 

 or 

 to get desired setpoint, then press 

 to lock the temperature in. 

 
 
When both heaters are programmed, press 

 again to store the programmed setpoints and exit the 

programming mode OR press either of the 

 buttons (1 or 4) to change the setpoint temperature for a heater.  

Program as previously described. 
 

Heater Plate

Temperature
Switch (1)

ON/OFF Switch

Down Switch (2)

Up Switch (3)

Check or

Program Switch

Air Heater

Temperature

Switch (4)

Display