Compatible Systems 10/100 ユーザーズマニュアル
Chapter 1 - Network Installation
3
Connecting a Management Console
To connect a management console, use the supplied cable and connect to the Console interface
on the 10-100 Ethernet - DES I/O card. You can use a dumb terminal or a computer equipped
with VT100 terminal emulation.
on the 10-100 Ethernet - DES I/O card. You can use a dumb terminal or a computer equipped
with VT100 terminal emulation.
The default settings for the Console interface are VT100 terminal emulation, 9600 bps, 8 bits,
no parity, 1 stop bit and no Flow Control.
no parity, 1 stop bit and no Flow Control.
v Note: The 10-100 Ethernet - DES I/O card also has an AUX interface. This is a modem
connection which should only be used in consultation with Compatible Systems Technical
Support staff, who will provide instruction on its use.
connection which should only be used in consultation with Compatible Systems Technical
Support staff, who will provide instruction on its use.
v Note: If you want to use Telnet as a management method, you must first configure an IP
address into the server using an out-of-band console, or reconfigure the IP address on an IP
host or workstation on the same Ethernet segment as the server. See Chapter 4 - Command
Line Preparation in the IntraPort Carrier Chassis section of the manual for more information.
address into the server using an out-of-band console, or reconfigure the IP address on an IP
host or workstation on the same Ethernet segment as the server. See Chapter 4 - Command
Line Preparation in the IntraPort Carrier Chassis section of the manual for more information.