Chicco KEYFIT 30 ユーザーズマニュアル
36
37
1
.Position Carrier.rear.facing.on.
vehicle.seat,.with.child.properly.
secured.in.Carrier.
secured.in.Carrier.
2
.Route Vehicle Belt.under.
both.Belt.Guides,.and.buckle.the.
vehicle.belt.
vehicle.belt.
3
.Tighten Vehicle Belt while.
pushing.Carrier.firmly.into
vehicle.seat..
vehicle.seat..
Put the vehicle belt in the locked mode,
see vehicle owner’s manual for more
information.
A tightly rolled towel may be used
A tightly rolled towel may be used
under the front edge of the Carrier if
needed to adjust the angle of the
Carrier. Angle is correct when level
line on Carrier is level with ground.
4
.Check Installation:
.
a
.Level.Line.on.Carrier.MUST..
. . be.LEVEL.with.ground.
.
b
.Vehicle.belt.MUST.be.TIGHT..
.
c
.Carrier.MUST.be.STABLE
. . and.secure.
Uninstalling Base
Remove.Carrier.from.Base
Remove.Carrier.from.Base
1
.Loosen LATCH.by.lifting.the.
LATCH.Release.Lever.and.pulling.
Base.away.from.vehicle.seat.back.
Base.away.from.vehicle.seat.back.
2
.Detach LATCH Connectors.
by.pressing.the.red.button.on.each.
LATCH.Connector,.and.remove.
Base.from.vehicle.
LATCH.Connector,.and.remove.
Base.from.vehicle.
Storing LATCH
Insert LATCH Connectors into
storage pockets.
Insert LATCH Connectors into
storage pockets.
a
.
1
.Pull LATCH Pull Strap.to.
secure.LATCH.Connectors.
2
.Roll LATCH Pull Strap.and.
store.in.Pull.Strap.Storage.Pocket.
NEVER travel with CHILD RESTRAINT unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
When not using LATCH, the LATCH Connectors and Pull Strap
MUST be stored properly.
1
2
1
a
.
2
a
.
INSTALLATION WITHOUT BASE
NEVER install CARRIER without Base using a non-locking
vehicle belt. The installation will NOT be secure. Refer to your
vehicle owner’s manual for detailed vehicle belt information.
INSTALLATION USING LATCH
a
.
b
2
3 4