Desa HRC101 ユーザーズマニュアル

1.   Disconnect switch wires from the control valve. 

Some units will have an on/off switch with 

switch plate that is connected to the control 

valve. other units will have a jumper wire that 

will need to be removed from the control valve 

(see figure 1).

2.  Remove screws and switch plate as shown in 

figure 1. Discard after removing.

3.  Install remote receiver unit onto gas log heater 

base using clips (2) and insulating washers 

provided.

4.  Push clips firmly into place (see Figure 2).

5.  Connect wires as shown in figure 3.
Note: 

On yellow flame models, reuse provided

phillips head screws and reinstall heat shield over 

receiving unit.

Two 9-volt alkaline batteries (not included) are 

required to operate this wireless hand held remote 

control set. One battery must be installed in the

receiver and one in the hand-held remote control 

unit. Note: Only use alkaline batteries.
Installing 9-volt Battery (not Included) in 
Receiver 

1.  Locate the battery clip mounted on the back

of the receiver. 

2.  Slide a 9-volt battery through the clip.

3.  Attach the terminal wires to the battery.

Front

Back

Wires to 
Control Valve

Screw

Jumper Wire

Control Valve

Front

Back

Insulating 
Washers

Remote 
Receiver

Mounting 
Clips

Valve

Red Wire 
From 
Receiver

White 
Wire From 
Receiver

Battery Clip

ON/OFF Switch with 
Switch Plate