Jensen VM9022HDN ユーザーズマニュアル

13

VM9022HDN

Open TFT Monitor
Press the OPEN button (1) on the front panel or press the 
(

) button (25) on the remote control to slide the monitor 

panel down to reveal the disc and SD card slots.
Close TFT Monitor
Press the OPEN button (1) on the front panel or press the 
(

) button (25) on the remote control close the monitor 

panel.

A known characteristic of LCD panels is the quality of the 

display in relationship to the viewing angle. The monitor 

angle can be adjusted for optimum viewing using one of the 

following methods.
Step by Step Angle Adjustment
Press the (

) or (

) button on the remote control (26, 27) 

to adjust the tilt angle of the screen one step at a time.
Continuous Angle Adjustment

 the (

) or (

) button on the control panel 

or remote control to adjust the tilt angle in a continuous 

motion.

If the rear-view video camera is connected, the unit is on, and 

the monitor is stationed inside the main compartment of the 

unit, the monitor automatically moves into the viewing 

position and switches to CAMERA mode upon reverse 

driving. When the reverse driving stops, the monitor returns 

to the main storage compartment.
If the monitor is in display mode, the monitor automatically 

switches to CAMERA mode upon reverse driving. When the 

reverse driving stops, the monitor returns to its original input 

mode.

Press the WIDE button (28) on the remote control or WIDE/
PIC

 button (7) on the monitor to adjust the aspect ratio as 

follows (only active with video source):

Table 2 shows the video output mode for each playing 

source. 

*CVBS – Composite Video Baseband Signal

Parameter Adjustment Procedure
1.

Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or press 
and hold

 the WIDE/PIC button (7) on the monitor.

2.

Select Item to Set:
Use the up/down joystick buttons to select “BRIGHT” or 

“CONTRAST”.

3.

Set Parameters:
Use the left/right joystick buttons to modify the settings.

4.

Exit Picture Quality Setting Mode:
Press the PIC button on the remote control or the WIDE/
PIC

 button on the monitor 

When the pink "Parking" wire is connected to the vehicle 

Parking Brake circuit, the front TFT monitor will display video 

when the Parking Brake is engaged. (When the pink wire is 

grounded via the Parking Brake circuit, video will be 

displayed.) 

RADIO

RGB Mode

SAT

RGB Mode

DISC

RGB Mode

BT

RGB Mode

AUX 1

CVBS Mode

AUX 2

CVBS Mode

NAV

RGB Mode

CAMERA

CVBS Mode

CINEMA

The entire screen is extended 

horizontally to the aspect ratio of 16 to 

9. The extension ratio is the same at 

any point.
NORMAL

The conventional display image has a 

4 to 3 ratio of horizontal to vertical, 

leaving a blank area on the right and 

left sides of the display.
STANDBY

Screen becomes black. Touch screen 

to resume.