Brother MFC9130CW ユーザーズマニュアル
104
Drum End SoonX
1
(
X
) shows the drum
unit color that is near
the end of its life.
(BK)=Black,
(Y)=Yellow,
(M)=Magenta,
(C)=Cyan.
the end of its life.
(BK)=Black,
(Y)=Yellow,
(M)=Magenta,
(C)=Cyan.
The drum unit for the color
indicated on the Touchscreen
is near the end of its life.
indicated on the Touchscreen
is near the end of its life.
Order a new drum unit for the color indicated on
the Touchscreen before you get a
the Touchscreen before you get a
Replace
DrumX
message.
Drum !
The corona wires on the drum
units must be cleaned.
units must be cleaned.
Clean the corona wires on the drum units (see
Cleaning the corona wires on page 82).
Cleaning the corona wires on page 82).
The drum unit or the toner
cartridge and drum unit
assembly is not installed
correctly.
cartridge and drum unit
assembly is not installed
correctly.
Put the toner cartridge into the drum unit that is
indicated on the Touchscreen. Then reinstall
the toner cartridge and drum unit assembly into
the machine.
indicated on the Touchscreen. Then reinstall
the toner cartridge and drum unit assembly into
the machine.
Drum Stop
It is time to replace the drum
unit.
unit.
Replace the drum unit for the color indicated on
the Touchscreen. (see Replacing the drum
units on page 86).
the Touchscreen. (see Replacing the drum
units on page 86).
Fuser Error
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
unit does not rise to a specified
temperature within the
specified time.
Press and hold down
to turn the machine
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
again. Leave the machine idle for 15 minutes
with the power on.
The fuser unit is too hot.
Jam 2-sided
The paper is jammed
underneath the paper tray or
the fuser unit.
underneath the paper tray or
the fuser unit.
Jam Inside
The paper is jammed inside the
machine.
machine.
Jam Manual Feed
The paper is jammed in the
manual feed slot of the
machine.
manual feed slot of the
machine.
Jam Rear
The paper is jammed in the
back of the machine.
back of the machine.
Jam Tray
The paper is jammed in the
paper tray of the machine.
paper tray of the machine.
Limit Exceeded
The print limit set in Secure
Function Lock 2.0 was
reached.
Function Lock 2.0 was
reached.
Call your administrator to check your Secure
Function Lock Settings.
Function Lock Settings.
Log Access Error
The machine could not access
the print log file in the server.
the print log file in the server.
Call your administrator to check the Store Print
Log to Network settings.
Log to Network settings.
For more information, see Network User's
Guide: Store Print Log to Network
Guide: Store Print Log to Network
Low Temperature
The room temperature is too
low for the machine to operate.
low for the machine to operate.
Increase the room temperature to allow the
machine to operate.
machine to operate.
Error Message
Cause
Action