Brother MFC9130CW ユーザーズマニュアル
Loading paper
23
2
d
Use both hands to push one sheet of
paper firmly into the manual feed slot
until the top edge of the paper presses
against the paper feed rollers. Continue
pressing the paper against the rollers for
about two seconds, or until the machine
grabs the paper and pulls it in further.
paper firmly into the manual feed slot
until the top edge of the paper presses
against the paper feed rollers. Continue
pressing the paper against the rollers for
about two seconds, or until the machine
grabs the paper and pulls it in further.
NOTE
• If the error message
Jam Manual Feed
appears on the Touchscreen, the machine
cannot grasp and pull the paper. Reset
the machine by removing the paper and
then pressing
cannot grasp and pull the paper. Reset
the machine by removing the paper and
then pressing
Start
on the Touchscreen.
Reinsert the paper and be sure to press it
firmly against the rollers.
firmly against the rollers.
• Put the paper into the manual feed slot
with the side to be printed on face up.
• Make sure the paper is straight and in the
correct position on the manual feed slot. If
it is not, the paper may not be fed
correctly, resulting in a skewed printout or
a paper jam.
it is not, the paper may not be fed
correctly, resulting in a skewed printout or
a paper jam.
• Pull the paper out completely when you
retry putting the paper into the manual
feed slot.
feed slot.
• Do not put more than one sheet of paper
in the manual feed slot at any one time, as
it may cause a jam.
it may cause a jam.
• To easily remove a small printout from the
output tray use both hands to lift up the
scanner cover as shown in the illustration.
scanner cover as shown in the illustration.
• You can still use the machine while the
scanner cover is up. To close the scanner
cover, push it down with both hands.
cover, push it down with both hands.
e
After the Touchscreen shows
Manual Feed
, return to step d to load
the next sheet of paper. Repeat for each
page you want to print.
page you want to print.