Bunn FPG-2 ユーザーズマニュアル

31

P1036

FIG. 22 CIRCUIT BREAKER

P1037

FIG. 23 CIRCUIT BREAKER TERMINALS

RED from Motor-LPG-2E

BLK from Start Switch-LPG

BLK from Power Cord

Removal and Replacement:

1.  Remove the wires from the circuit breaker.

2.  Remove the face nut securing circuit breaker to the 

motor support.

3.  Remove circuit breaker.

4.  Install new circuit breaker in motor support and 

secure with face nut.

5.  Reconnect the wires.

6.  Refer to FIG. 23 when reconnecting the wires.

Location:

  The circuit breaker is located on the rear of the 

grinder next to the power cord strain relief bushing. The 

circuit breaker is not available on Model LPG equipped 

with capacitor.

Test Procedure:

1.  Disconnect grinder from the power source.

2.  Remove the wires from the circuit breaker.

3.  Check for continuity between the terminals. Conti-

nuity must be present between the terminals.

If continuity is present as described the circuit breaker 

is functioning properly.

If continuity is not present as described, press reset 

button and repeat step #3, if continuity is not present 

as described, replace the circuit breaker.

41545 122209