Bosch Appliances Computer Monitor UML-273-90 ユーザーズマニュアル
Connecting an Alarm Trigger
The monitor contains an alarm Trigger Input and a Trigger cable.
These components allow you to connect an alarm relay from a
device, such as a camera or a door. Connect the two flying leads
from the Trigger cable into the relay out ports of the device.
Then, route the other end of the cable to the Trigger Input
connector of the monitor. The following illustration depicts a
typical alarm relay configuration.
These components allow you to connect an alarm relay from a
device, such as a camera or a door. Connect the two flying leads
from the Trigger cable into the relay out ports of the device.
Then, route the other end of the cable to the Trigger Input
connector of the monitor. The following illustration depicts a
typical alarm relay configuration.
Figure 5.5: Camera to Monitor Relay
Number
Description
1
Dinion Camera
2
Flying Leads Connected to Trigger Outputs3 and 4
3
UML Back Panel
In the above example, the flying leads of the Trigger cable are
connected to Trigger output three and four of a Dinion camera.
The cable is routed to the back panel of the UML monitor and
the plug-end of the wire is connected to the Trigger Input port.
Refer to Setting Menu, page 53, for configuring alarm
acknowledgement.
5.7
32
en | Installing the Monitor
Bosch High Performance
HD LED Monitors
2013.02 | 3.0 |
Installation Manual
Bosch Security Systems, Inc.