Wyse Network Router 1 ユーザーズマニュアル

Chapter 3

• Delay before repeat - Repeat parameters for held-down key. Delay before repeat 

selectable from 1/5 second to 2 seconds, or no repeat. The default is 1/3 second.

• Repeat Rate - Select Slow, Medium, or Fast. The default is Medium.

The Network Setup dialog box allows you to configure thin client network settings 
(including operation in modem dialup and PPPoE modes, as well as locations of servers 
essential to thin client operation). 

If required by the operating environment, the network administrator may 
disable access to this dialog box. Specifically, it cannot be accessed by 
Non-privileged and Low-privileged users (and not until after log on if using 
dial-up or PPPoE access). In addition, if the network administrator has set 
the lockdown mode by means of an entry in the user profile, both system 
reset and access to this dialog box are disabled for Stand-alone users as 
well.

For more information about system lockdown, refer to "Understanding System 
Lock-down."

Use the following guidelines:
• Ethernet Speed - Normally the default (Auto-Detect) should be selected, but another 

selection can be made if automatic negotiation is not supported by your network 
equipment. Selections include Auto-Detect, 10 Mb Half-Duplex, 10 Mb Full-Duplex, 
100 Mb Half-Duplex, 100 Mb Full-Duplex.

The 10 Mb Full-Duplex option can be selected locally at the device, 
however, this mode may need to be negotiated through Auto-Detect.