Lightwave Communications USB-Wizard ユーザーズマニュアル

9

Once the 

USB Wizard switch is properly connected, the USB Wizard will enable a connection to be made between the

CPUs attached to its VIDEO  and CPU ports and the monitor and input devices attached to

 the MONITOR and DEVICES ports.

The LEDs on the control panel of the 

USB Wizard will illuminate depending on which port (and corresponding CPU) is being

connected to the monitor and input devices.

The 

USB Wizard can be controlled by three methods:

•

 

front control panel using touch-switches and LEDs

•

 keyboard 

control 

through Command Mode

•

 

mouse clicks from within some menus of OSD Command Mode (optional).

        There is a touch-switch and LED on the front panel of the 

USB Wizard for each CPU the switch will connect the monitor

and input devices to.  Pressing any touch-switch on the front panel of the 

USB Wizard will connect the corresponding CPU 

to the monitor and input devices.
        Holding down any front panel touch-switch for more than 2 seconds will cause the 

USB Wizard to cycle through

all modes of operation including COMMAND, SCAN, and NORMAL (described below and on page 11).  The two
MODE LEDs on the front panel indicate which mode is selected. Release the touch-switch when the LEDs indicate the desired
mode.  When no mode LEDs are illuminated the user is in Normal Mode controlling directly the CPU to which the user is
connected through the 

USB Wizard.

Keyboard control of the 

USB Wizard can be achieved using either of two methods:

 

•

  Basic Command Mode- operated strictly by using keyboard commands as instructed below. Basic Command Mode

     is only applicable if the OSD option is not built into the switch.

       

•

 OSD Command Mode (optional)- operated using the keyboard and mouse in conjunction with OSD menus superimposed

           onto the monitor.   If OSD is built in, use the menus as instructed on page 11.

        By pressing <Ctrl> + < ` > (accent key),  the user can enter Command Mode (either Basic, or OSD). Once in Command
Mode, typing a series of commands will cause the 

USB Wizard to connect the user to any one CPU connected to the switch. 

Pressing the <Esc> key will exit Command Mode.

In order to control the 

USB Wizard with the keyboard connected, Command Mode must be enabled. To enter Command Mode

from the keyboard:

                                           Press