are switched on and off automatically depend-
ing on ambient light conditions, e.g. in a tunnel,
in twilight, rain or snow. The LED next to the
symbol is illuminated when the low beams are
on.
You can leave the switch in position

1 when you

switch off the engine. Once you open the
driver's door while the ignition is switched off,
the outside lamps automatically go out.

The low beams remain switched on inde-
pendent of the ambient lighting condi-

tions when you switch on the fog lamps

The automatic headlamp control cannot
serve as a substitute for your personal

judgment in determining when the lamps
should be switched on in response to ambient
lighting conditions. For example, the system
cannot detect fog. To avoid safety risks, you
should always switch on the lamps manually
under these conditions.

Adjusting sensitivity

iDrive concept, refer to page

Press the

button.

This opens the start menu.

Press the controller to open the menu.

Select "Vehicle settings" and press the
controller.

Select "Lighting" and press the controller.

Select "Auto. headlamps" and press the
controller.

Select a menu item:

"Sensitive"

"Normal"

"Slower"

Press the controller.

Parking lamps

In switch position

2, the front, rear and side

vehicle lighting is switched on. You can use the
parking lamps for parking. For lighting on one
side for parking as an additional feature, refer to
page

The parking lamps will discharge the bat-
tery. Do not use them for unduly long

periods of time, as otherwise the battery might
not have enough power to start the engine.

Low beams

When the switch is in position

3, the low beams

are on only when the ignition is on; with the igni-
tion off the parking lamps are on.